View Full Version : Drivetrain
- Not getting full power?
- 8.8 Clarification
- diff tech IRS Nine Inch any have one/ whats the price/ any good
- possible damage
- stall single disc/3 disc
-
- new rear gear fluid coming
- Cam install question??
- Warning if you never checked your fill plug
- M6 owners - Billet Shifter installed! (review inside)
- Rear Diff Leak
- One piece diveshaft??????
- Fan belt part number question?
- Bolt fell off rear axle after 3.91 gear install!
- cheap gm,torco friction modifier.
- Does this look like a "new" rear end to you
- Will it hold??
- I found my clunking noise
- Converter labor
- U joint half shafts vs CV half shafts.
- 3.91s in a hurry???
- IRS Issues (long!)
- wuts the best clutch?
- 8.8 conversion
- Bought a used Harrop cover, needing? a few things for it
- GMM Ripshifter bolts came loose
- Need input
- Transmission question
- People who have installed LS7 clutch...
- b&m shifter issues
- in car vid after tcm install?
- T-56 trans parts.
- Clutch swap $$$????
- G8 six-speed automatic
- Genuine GM Replacement Parts!
- Not sure what kind of clutch problem this is
- LS7 Clutch Help
- A4 transmission reliability
- Anyone heard of...
- GM's solution for wheel hop
- Info about Dana corp and GTO irs
- Pinion seal
- DIY Mechanic Differential Replacement?
- 11 sec. or faster what clutch?
- Growling noise after converter install
- difference between flywheels
- stall from 4l60 work in 4l65??
- Drive Shaft Safety Loop
- HELP!!!! A4 filter seal
- Research help needed on cv joints and shafts
- GMM Race review
- A4 trans problem, please help.
- Ethyl n GMM n Ethyl n Hurst -
- has anyone broken a BMR axle stub
- narrowed 9inch 4 link in my gto
- Pictures of trans wiring?
- First and second gear syncro's GONE???
- anyone know WHo has a hurst in stock?
- Squeal during clutch engagement - what is it?
- clutch feel
- Difftechs Make your own special Sale!
- Gravana Power Servo?
- TTY bolts for diff swap
- short shifter
- What would cause the slave seal to pop? (LS7 clutch related)
- Billet Pro Shifter installed
- M6 vs A4 Gearing
- Hurst question
- Those who have 3.91s...
- gas mileage with 3.91's
- Which noise is it?
- Anouncement from PerformaBuilt
- Help with Clutch Slave and Stainless Line
- Ethyl's Clutch, Hydraulics, Shifter, and CAI
- Getting a whole new rear, oil breakin questions
- Tough to shift in the cold?
- Harrop short throw shifter??
- PerformaBuilt Weekend Sale! Starts at 2 PM-
- Orssom Short Shifter install
- Rearend noise
- Grinding in 1st
- billet shifter: where to buy..
- Trashed DS Coupler *Pics*
- hurst shifter thread size?
- Clutch engagement question
- axle stubs
- Rearend leak
- Help. Intermittent high pitch whine?
- powder coat hurst chrome stick?
- New spec clutch and b&m shifter
- 4l60e question
- Paddle Shifting...
- diff fluid change?
- Driveshaft???
- rear end help!
- Spec Stage 5?
- clutch questions??
- GMM Ripshift Shifter Question.
- Bass Drums in my rear end
- Clunking when braking
- Lou's Short Stick installed Pic
- Need A New Drive Line???
- 3200 Yank Conv. review
- Harrop Sports Diff Cover - 6 only.
- 3.91
- SPEC 2+ What Is The Latest Opinions?
- whining noise...
- Help with GMM street that is missing a bolt!
- crossmember
- Another Flywheel Thread
- Gears
- Adapting trans cooler to into factory system?
- Clunk when shifting into first
- And it begins.... Should I take her in?
- anybody still have this spreadsheet?
- Performabuilt trans arrived yesterday
- Need help with trans. temp. gauge installation
- What Is The Stock Gear Ratio For The Rear End In A 2005 Gto
- Shifter Advice for Daily Driver
- 3.91's top speed??
- Eaton Diff Available Q4
- can someone fill me in
- Pontiac GTO 6-Speed Billet Pro Series Short Shifter
- LSD Check Complete - Update on my Diff
- 8.8 swap???? Need Help, finishing pieces
- Just ordered my 8.8 from DSS
- Modifying stock clutch master
- Is this normal wheel hop trauma?
- What weight Torco for Kaaz
- rear diff fill plug
- Rear Diff on its last leg!!! Anyway to Rebuild?
- just curious
- Fixed my GMM rattle
- NON-GTO rearend question
- Viper T-56 Fitment
- Dealer said my tranny fluid was 2 qts low
- Anyone besides T-Bone done the 4L80E swap?
- Sticky Shifting
- So the LS7 clutch causes MORE wheel hop?
- EXTREME vibration on 200 MPH driveshaft over 100 MPH
- Need ideas on clutch problem
- Need plastic dust boot cover p/n (m6)
- Twisted Stubs In ½ A Mile.
- DSS 1000hp stub to hubs arrived today
- Clutch pedal feels spongy at times.
- single disk vs tripple disk
- rearend output axle movement??
- Looking for a junk center section
- Installing the GMM shifter...torque specs
- Clutch problem or is it normal
- ok looked and cant find it
- Hays clutch
- Need help finding a rubber boot......
- A peek at Ethyls underside-DS Vibration Saga
- Help Carier Bearings Asap
- My 4L65E chose to dump all its fluids out today
- Bolts For Transmission Brace
- rear end whine -positive outcome-
- ACC Torque Converters?
- Clutsh install
- harrop cover and magnaflow?
- M6 leaking trans fluid but only on an incline...
- The Right Fluid?
- Fidanza clutch package
- Part # for the trans rubber dust cover?
- C5 Z06 Shift knob
- clutch problems/good shop?
- Drivetrain Upgrades
- Quick fix for those of you who broke the stock shift knob
- Nightmare has begun....
- yanks converter/trans tune??
- Hurst Competition Plus Shifter
- 2nd fully built tranny/new master, bendix slave, ss clutch line, oz700.. WTF??
- Heavy Duty Clutch Belt
- CVT on GTO?
- Flexplates that will hold 600rwhp??
- auto scattershield
- bad clutch? not sure.
- tex oz700 clutch
- Transmission whine fixed...
- transmition life?????
- No 2nd and 4th gear?
- broken 1/2 shaft guys come in
- Odd Clutch
- 3rd and 4th are slippin!!!
- HELP!!!!! cant get tranny back in
- SPEC stage 2+ clutch
- 4L60E question
- Newbie Questions!
- Wheel Bearings
- HELP!!! Installation of SS Lines
- a4 to m6 swap
- Changed my trans fluid ...
- Z06 Shifter
- Newly installed Hurst?
- Guys with 05/06 A4 cars.....NEED TUNE!!!
- Pedders diff insert installed! Review inside
- Question about M6 launches
- Questions on Upgrades (CAM/DShaft/CV Shafts)....
- What is leaking / seeping?
- What will break First?
- Billet FTW
- Clutch guys - LS7 or RAM Level 4 Powergrip HD clutch?
- Replacing wheel stud?
- HELP...I Am Beginning To Feel Like An Idiot
- Need another method to remove M6 shift knob.
- Torque Converter Lock Up Education
- GM Parts House February 2008 GTO Specials!
- Need your help after dealer visit with shifter rattle issue.
- A4 Gears
- newbie question
- LuK clutchs???
- any tips for 3-4 shift with billet pro shifter?
- Looking for factory stubs
- Fluid and Filter
- Clutch??
- Some slave problems...need suggestions
- posi problem need advice
- I can't believe this!
- Momo knobs on threaded LSS?
- 6L80e hmmmm
- clutch throw shortens...problem!
- Who Wants A Free 2008 GM Performance Parts Catalog?
- Got 3200 yank stall tuned
- i just wanna know
- 3 Diff Questions ???
- What wieght Gear Oil ???
- Sludgey stuff in my clutch fluid?
- Where to get Torco Diff fluid & Friction Mod. ???
- 408 M6 with 3.91 vs 3.73
- Which royal purple tranny fluid?
- Few Questions on Half Shaft replacement
- 3.91's or 4.10's?
- Parts needed to adapt after market trans cooler to factory cooler?
- Does the GTO have any grease fittings ???
- for those with a Line lock kit and no drag bags.
- Half shaft bolts
- Dependability question
- Should I be worried about my car?
- OEM diff torque sensing?
- Bird if Prey clutch pic's
- Tranny problems -- is it TCM or is a tranny rebuild in order?
- A History of Violence
- Help! Slave bolt thread question.
- Failed 6 Speed Transmission
- Rear Center Section Change?
- Shift knob
- This was me yesterday...
- Yella Terra Steel Billet Flywheels
- LS7 Clutch Questions
- Rear Transmission Mount
vBulletin® Copyright ©2000-2010, Jelsoft Enterprises Ltd.