Bogart Drag Wheels ?????

[Ls1Jeeper]

I've been searching threads for 45min now. Does anybody have these on there car thats been lowered ?? I want to try and get them to go up in the fender well or the rear. The front I just don't want them sticking out past the fender. I don't care if I have to cut/weld/grind a little just nothing that will hurt the look of the car.


Heres the ones I'd like except the rears to be welded but with the bead lock. Is there anyway to get a smaller center cap that thing is way to big


http://www.bogartracingwheels.com/rt-welded-front.jpg



http://www.bogartracingwheels.com/rt-with-beadlock.jpg

[gtore62]

i'm running the gt's, and had to do some banging and grinding but just on the inside, the long line on the a arm is the area i had to grind a little and the rest of the pics. show the rest. stock springs aribag set at 11psi and no rub. the fronts do stick out.

[Ls1Jeeper]

Those looks good that was the tire size I was going to run too. I'm sure I'll have to cut on the lower arm .. How far did you have to beat the inner fenders in ?

[gtore62]

i would guesstimate about 1/8 and and just a tad of grinding. one note is that you may not be right on center with the rear, at least it seems that way to me, one side rubs a tad more than the other. you'll need a 3lb hammer.

[Ls1Jeeper]

Thats not that bad 1/8" isn't much. I just hate to have to jack the rearend up like a foot in the air, so I'd rather "make it fit" lol

[gtore62]

here are some more pics. to give you a better idea.

[Ls1Jeeper]

what size front tire is that ? Will the rear tire go up in the fender well at all like when it leaves the line

[gtore62]

i think it's a 3003, et front for sure.

[Ls1Jeeper]

I was thinking of using a 24" on the front since thats about the height of the factory 18's