Please Help Back Spacing

[BIZZOMB75]

hello, can anyone tell me if the set up will work, if needed i can machine, or add spacers etc... please help
Wheel Diameter (Inches):
18"
Wheel Width (Inches):
8.5" Front and 9.5" Rear
PCD Bolt Pattern:
5x120
Offset:
30mm

[Merle]

hello, can anyone tell me if the set up will work, if needed i can machine, or add spacers etc... please help
Wheel Diameter (Inches):
18"
Wheel Width (Inches):
8.5" Front and 9.5" Rear
PCD Bolt Pattern:
5x120
Offset:
30mm


Won't work. Do a search on here before asking questions that have been asked a gajillion times. You need at least +45mm of offset on a 9.5" wide rear wheel and will then still have to roll, grind, bend, tweak, etc. to make them fit with a 275 width tire. ou got the bolt pattern right though.

[BIZZOMB75]

i did alot of looking on the forum but I never came across a concrete answer. can I add a wheel spacer to make it fit? I dont mind rolling my wheel well.

[Orkboyz]

Adding a wheel spacer is the same as decreasing the offset. So if you add a 5mm spacer to a 30mm offset you effectively have a 25mm offset. Now your wheel/tire combo is further out than it was before.

[Merle]

Do you know the difference between offset and backspace? They are not one in the same.