Axis Shine problems

[txcharlie]

OK, I have had these wheels for almost 3 months and have about 25 miles on them. I can't get the front wheels to work right. I ordered some billet hub rings and thought that would fix me up.....wrong! Well, now I know what the problem is. The center bore on the wheel goes about 3/8 in deep and then begins to taper to a smaller diameter. The sleeve(don't know what to call it) that the center of the wheel mounts, is about 5/8 in long, so when wheel is mounted, there is about a 1/4 in space between the wheel and rotor face. So any ideas? I have thought of a few solutions: 1 have the center of the wheel bored out. 2 Put a spacer between wheel and rotor. 3 Sell the wheels.
Any help would be greatly appreicated.
Charlie

[Octomonkey]

Ask Rolencode GTO or alphaqGTO. They have these currently installed, so they may know what your issue is. Mine are still currently stacked up, and not on my car, so I cannot address your issue. :(

[ShelbyGoat]

If you feel froggy and think you can do it, a dremel might work nicely, if not take them to a reputable wheel shop and have them address the issue. If you live in an area similar to mine, you would not want a sole touching them anywhere.

Good luck.

[Red2005Goat]

I have Axis Shine 19x8.5 ET 35 in Front on stock 2005 rotors with no problems.

[6goat.tail0]

Hey did Axis take care of your issue. Hope there rolling right when you get the back.

[txcharlie]

I am sending the wheels back to have the center bored out. They told me that a few of the wheels were made to BMW specs, which was a 10mm depth of the center bore. Well, our cars need a 15mm depth.
I have the wheels ready to be picked up by shipper. Hopefully this saga will end in a couple of weeks when I get them back.

[MMB05]

I know this is an old post, but I wanted to bump since I had the same issue. I just threw 5mm spacers in the front. Fixed the issue. Again, I am bumping for anyone else who has a similar issue.

[GTOhaas07]

I know this is an old post, but I wanted to bump since I had the same issue. I just threw 5mm spacers in the front. Fixed the issue. Again, I am bumping for anyone else who has a similar issue.

At least you searched. Yep, same problem here. Had to have the centers bored out but now I can't get the center caps on the rears.

[Octomonkey]

I couldn't get the center caps on my rear wheels, either. I ended up cutting off the tabs and glued them on.