Wheel stud sizes.

[Spyral]

I searched and no one seems to know a NAPA part number for front wheel studs. Well, since I had an emergency yesterday and needed some, I did some research. If you are looking for stock replacements, you can go to NAPA and give them part number 641-2196. These are $1.89 each. They are for a Mitsubishi Lancer Evo VIII. They spec out identical to our stockers. .565 knurled stud, 12mm x 1.50 RHT, 43mm long. The guy at NAPA said it was not possible, so I had him mic them. Yep, exactly the same!

For the rears, use NAPA part number 641-1621. These are $2.06 each.

[svede1212]

yup the EVO. i got the ARP ones. a bit expensive but the others are very soft and quite a few people seem to get "emergencies" :)

[ls2 goat]

Good Find Spyral

[GagToe]

yup the EVO. i got the ARP ones. a bit expensive but the others are very soft and quite a few people seem to get "emergencies" :)

Spy has a good story behind this one :popcorn2:

[Spyral]

Spy has a good story behind this one :popcorn2:

Don't you have some toilets to clean?

[GagToe]

Don't you have some toilets to clean?

Already cleaned them, got to go vacuum here in a little bit.

[aquariussuperman]

Remember we have 5 bolts to torque for each rim, not just 2. Sounded like an emergency to me.:wall:

[Spyral]

Remember we have 5 bolts to torque for each rim, not just 2. Sounded like an emergency to me.:wall:

lol..I am just thanking GOD I didn't lose the rim and total my car! That was a total bonehead move on my part. Then, of course, the car got me back by falling on my leg.

[GagToe]

lol..I am just thanking GOD I didn't lose the rim and total my car! That was a total bonehead move on my part. Then, of course, the car got me back by falling on my leg.

I just lol'd again :gr_jest:

[Spyral]

I just lol'd again :gr_jest:

I should drop a GTO on your leg.

[04blackgmc]

Good info!