Joined
·
263 Posts
Hello Leon,
I just installed my billet JHP shifter yesterday and I'm having trouble with shifts. I cannot get it into 2nd gear. 6th is tough but can get it in. I had old billet instructions that were great but it looks as though the design changed slightly when JHP took them over. The instruction I found on the web was the old red billet one that showed the half circle adjustment plates at the top and rear of the handle. He said adjust it third and fourth gear moving the plate to tough the shift handle. The new product has these plates on the inside of the linkage. Due to this, I went for the install without touching it, bad idea. 2nd gear is a no-go. Did you get instructions from JHP? You would think for a $500 shifter there would be instructions. Help if you can....Thanks, Richard
I just installed my billet JHP shifter yesterday and I'm having trouble with shifts. I cannot get it into 2nd gear. 6th is tough but can get it in. I had old billet instructions that were great but it looks as though the design changed slightly when JHP took them over. The instruction I found on the web was the old red billet one that showed the half circle adjustment plates at the top and rear of the handle. He said adjust it third and fourth gear moving the plate to tough the shift handle. The new product has these plates on the inside of the linkage. Due to this, I went for the install without touching it, bad idea. 2nd gear is a no-go. Did you get instructions from JHP? You would think for a $500 shifter there would be instructions. Help if you can....Thanks, Richard