Nope, you have all you need, a piece of 2 x 4 for support on the bottom of the oil pan as you need to lift the engine to get them in place. The right side was more difficult for me on both cars I did as there is not as much room to maneuver the old mounts around when you go to take them out. There are a couple of lines on the front of the oil pan that need to have the bolts taken out of the clamps to allow you to move them some, other than that its pretty straight forward once you get the skid pan off and take a good look at it. You will probably cuss the old mounts once or twice getting them out but they will come out. Save the heat shields as you need to put them back on top of the new mounts, don't forget to put them on cause it sucks to lift the motor back up after you have them in place. Ask me how I know!!!
Everything he said plus you might need a saw because the threads on mine were to long so we had to cut them down. If you do have to do this dont forget to screw the nut down lower so it will clean up the threads on the way off.
OP, did you ever get around to doing this? I just did mine this weekend and it was "simple" enough... the clearance is the toughest thing. Also helps to have a swivel joint to remove the the bolts for the brackets. I couldn't get the motor high enough because of my headers.
let me know if you need more details. or if you already did it then disregard!
Cam: 228/234 .613/.613 112 TVS1900 in my garage... More Here...
2006 GTO PBM/Red M6 1 of 417
2010 Jeep Wrangler Unlimited Rubicon-SOLD-
2013 Jeep SRT8 Vapor 1of400
2012 Ford Raptor Black/Black
This job is more difficult with 1 7/8 kooks, I had to cut the stock motor mount on the driver side and remove both heat shields. Took me most of the night last night.
Strange, the driver's side was the easier one for me. I found that removing the actual bracket from the motor was the best way to get everything removed and installed. the bolts took little effort to loosen from the block.
I will say that a second pair of hands is very helpful. I started Friday afternoon when we had 60* weather, then a cold front blew in, we ran out of light after a few hours and I finished the job in 30* weather...
did the trans mount too. the whole car shakes like a mofo now. Haven't been able to get on it yet but you can tell something was stiffened up. Even at start up the noise from the trans is extremely noticeable. Might have something to do with the CF drive shaft and the added vibrations...
The AutoGuide.com network consists of the largest network of enthusiast-owned enthusiast-operated automotive communities.
AutoGuide.com provides the latest car reviews, auto show coverage, new car prices, and automotive news. The AutoGuide network operates more than 100 automotive forums where our users consult peers for shopping information and advice, and share opinions as a community.