LS1GTO Forums banner

Maggie being sold on CL

967 views 10 replies 8 participants last post by  tmiller 
#1 ·
#2 ·
Thanks for the heads up. Just called him and put a reserve on it.









Jk
 
#3 ·
Zero shaft play
SHUT YO MOUTH! *Isaac Hayes voice*

Better pounce on it Phoenix
 
#7 ·
That's a 1st gen maggie
 
#9 ·
Was it a 112? Dont waste time with that +100Hp weak sauce blower. Buy my +300HP TVS, and if you can run E85 your compression will be fine.
 
#10 ·
1st gen has pressed on keyed pullies on the front of the jack shaft. It allows for a 1.5" pulley on the shaft I think. All newer ones have 4 bolts that hold them on. They allow for 2.7" pulley. I seen a 1st gen M112 peak at 14 psi on a stock 6.0. M112 and M119 look alike. Hard to tell which one it is.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top