Joined
·
1,845 Posts
For any folks out there using the 3D printed 8" subwoofer brackets, have you had trouble getting the rear desk panel back in place?
I picked up the Cerwin Vega subs folks have mentioned here and my rear deck panel sits up too high for the fasteners to go back in.
Any tips? I still have the rubber rings around the circumference on the subs...ditch the removable piece or the whole ring?
@Kfxguy @Stoopalini ?
See below:
I picked up the Cerwin Vega subs folks have mentioned here and my rear deck panel sits up too high for the fasteners to go back in.
Any tips? I still have the rubber rings around the circumference on the subs...ditch the removable piece or the whole ring?
@Kfxguy @Stoopalini ?
See below: