LS1GTO Forums banner

1 - 6 of 6 Posts

·
Mile High Air
Joined
·
3,070 Posts
Discussion Starter #1
OK, need to re-baseline my current setup since I haven't dynoed with the 1 7/8s and the spin techs with my HPE S-cam.

After that comes the EDC cam test.

I'll be at MACs from 12-1 today. Come by if your bored. I know Mike will be looking for help on his car so that's a priority.
 

·
Here for the Gangbang
Joined
·
2,428 Posts
Man, I should strap mine down before it goes to Rhett.

Short Tube v. Long Tube - Title Match. Round One.

-Luke
 

·
Mile High Air
Joined
·
3,070 Posts
Discussion Starter #4
Had a lot of knock retard. Must have been bad gas since I've run the same advance with good results. Only put down 439 rwhp. I was running 28 previously and this time at 26 I had 5 degrees of KR. I was running rich the first run and got it back in line.

So, now I have somewhat of a baseline for the cam change.
 

·
Toon Dood
Joined
·
84 Posts
I made a trip to MAC later in the day too... Hoping to catch you there but I got to watch a couple WRXs...
 
1 - 6 of 6 Posts
Top