LS1GTO Forums banner

FJO controller Q - Problem

476 views 8 replies 3 participants last post by  Nmbr1GMfan 
I had problems with mine, it wasn't making sense to me. I ended up starting my laptop with the cables all hooked up, and it worked fine. Maybe just me though.
 
barkingspud said:
Nmbr1GMfan said:
I had problems with mine, it wasn't making sense to me. I ended up starting my laptop with the cables all hooked up, and it worked fine. Maybe just me though.[/QUOTE

Hey! Didn't you mount your controller under the hood? If so, how did you program it for WOT? On a dyno or did you do it before you did the final install? Also, how did you get the plumbing installed for the purge under your hood? Did you remove the hood insulator or just shove everything underneath with it still on?

Thanks in advance,

Mark
I mounted my controller underhood. unplug solonoids and turn key on and arm system to do WOT adjustment. I couldn't get the insulator off so I worked it undeneath. Check all my posts, my install is documented fairly well. TODD
 
barkingspud said:
Nmbr1GMfan said:
So, you did the WOT adjustment without moving the car? just arm the system and floor it (with the selenoids disconnected)? I'll check your posts.....

Thanks again!

Mark
Yes, if the key is on and n2o armed the adjustments to the FJO unit can be made no prob. just by holding your accelerator pedal down so the controller can get in sync with the voltage from the TB.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top