LS1GTO Forums banner

1 - 12 of 12 Posts

·
one life to live...
Joined
·
418 Posts
Discussion Starter · #1 ·
got my overlays for the pontiac logos (front & back, rims) & the instructions say to put some water on it before putting them down.
ok, makes sense if I wanna move them back & forth, but doesn't it hurt the adhesive????
 

·
WUT?!?!?!?!?!
Joined
·
6,524 Posts
No....just use a squeegee and get all the water out. I used a blow dryer and my drivers license...
 

·
Premium Member
Joined
·
82,628 Posts
Water evaporates and it then it sticks fine!
 

·
king of the castle....
Joined
·
726 Posts
I would use soapy water. Even windex works better than just plain water. But you may not have hard water like I do. :eek:
 

·
CAUTION!!!!
Joined
·
9,883 Posts
I just put on my steering wheel inlay (liquidomed) and the side emblem inlays and flags w/out water and though it took alot of lining up before sticking down, they look FREAKIN AWSOME!
 

·
WUT?!?!?!?!?!
Joined
·
6,524 Posts
phobos512 said:
Some dish detergent in a spray bottle is what I used, worked great!
Yeah I used a spray bottle with a soap/water mixture. The "wet" method works great...especially for the very small inlays...
 

·
Registered
Joined
·
204 Posts
gotzaGTO said:
I just put on my steering wheel inlay (liquidomed) and the side emblem inlays and flags w/out water and though it took alot of lining up before sticking down, they look FREAKIN AWSOME!
pictures please ?
 
1 - 12 of 12 Posts
Top