LS1GTO Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
76 Posts
Discussion Starter #1
I have to get new head gaskets because of the work i'm doing to this block.

I bored over the stock ls2 .040, I know what you are all thinking...UUUHH you can't go that far over. In truth I have found that if the sleave is .1 thick it will be ok and my block checks out just fine. People bore them .030 no problem the extra .005 on each side itsn't going to matter. SO my big problem here is finding a head gasket that fits. Will the factory gasket go back on and hold????
 
1 - 1 of 1 Posts
Top