LS1GTO Forums banner
1 - 4 of 4 Posts

·
Need To Drive More
Joined
·
1,489 Posts
Discussion Starter · #1 ·
05 GTO w/SW 1 3/4" Headers.

The number six cylinder plug boot is touching the primary tube. The stock plug wire has a 90 degree boot on it. Will the JBA's or other aftermarket wire clear the tube?

I searched and found this thread, http://www.ls2gto.com/forums/showthread.php?t=39640&highlight=jba+wires, but the headers are the JBA type.

Here is a picture from that thread with the JBA headers/wires (not my car)


It appears the boots are straight. Or are they? Anyone else have an issue with the stock plug wire touching a long tube header? Suggestions to remedy the issue?
 

·
Mclaren F1 LM
Joined
·
591 Posts
When installing headers it's a general rule you need to change the plug wires.
Jba sends you a set if you use there headers.
 

·
Wooohooo
Joined
·
3,381 Posts
MSD and Taylor Thundervolts clear. I had the Taylors and prefer the MSDs much better.
 

·
Registered
Joined
·
350 Posts
I have Taylor 10.4mm and they clear my SW's well. Also though, I had the 90* '05 wires on it and had no issues either.
 
1 - 4 of 4 Posts
Top