LS1GTO Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
100 Posts
Discussion Starter #1
I noticed yesterday that the screw used on the inside(closest to console)trim on both seats to cover the hinge sticks out almost 1/2" right into the side of the seat! You can see the screw by pulling the inside edge of the seat bottom where it meets the backrest toward you and looking in the corner right behind where the seatbelt catch is located. I couldn't see anyway to remove with removing the console so I just cut a piece of small vacuum hose a little longer than the screw and slid it over the screw so the hose is hitting the seat instead of the point of the screw. Don't want to know who designed that!:soapbox:
 
1 - 1 of 1 Posts
Top