LS1GTO Forums banner

1 - 3 of 3 Posts

·
Registered
2006 GTO M6 Flowmaster Axle back and K&N CAI
Joined
·
15 Posts
Discussion Starter #1
I have a K&N CAI right now and am looking to switch over to the Vararam intake. I was going through google looking at them, and noticed some had the air dam that is stock on the GTO, but cut or molded to fit the intake. most of them looked molded, with how perfect the fitment and lines on them where, if this is the case where could I get one of these? If not and I have to cut and make my own, where could I get a reproduction one so I don't feel bad cutting up an actual part of the car, as my car only has 23000 miles on it.
 
1 - 3 of 3 Posts
Top