So I called about a particular wheel this morning and asked if instead of the 5 on 4.75" bolt pattern it normally comes with, if they could do a set in 5x120.
I wouldnt think it would be a problem. The guy says no they cant do it. I then told the guy that if you do the math, 5 on 120mm is actually 5x4.72".
I then asked if they could just punch that number into their CNC and whip up a set? He says no! They can't! WTF!
So being that its only 3 hundredths of an inch off, anyone here suppose it would be safe to run anyways, considering the wheel will ultimately be off center by about 6 hundredths total? I should know the answer to this question but im asking it anyways.:stickpoke
I wouldnt think it would be a problem. The guy says no they cant do it. I then told the guy that if you do the math, 5 on 120mm is actually 5x4.72".
I then asked if they could just punch that number into their CNC and whip up a set? He says no! They can't! WTF!
So being that its only 3 hundredths of an inch off, anyone here suppose it would be safe to run anyways, considering the wheel will ultimately be off center by about 6 hundredths total? I should know the answer to this question but im asking it anyways.:stickpoke