I just purchased a Gentex GENK60 mirror with homeliink, temperature, compass and map light and was wondering if anyone here has installed this mirror. I am looking for a wiring diagram or pictures showing where each of the wires is oplugged into. I know that most of them will go into the interior fuse block but would like to get specific locations for each to make the install goes well. Can anyone help? Thanks for your assistance
JamesW
I used the ground in the visor, ran the power wire down the A pillar and tapped into the wiper fuse, I have the temp probe wire disabled.
i ran my wire down the passenger a pillar instead of the drivers side - i found a hole with a tiny rubber plug way up in the corner of the firewall on the passenger side ... it was perfect to run the wire for the temp sensor - i used the visor ground wire and then found switched 12v source under the dash near the glove box... works great...:thumbs:
Thanks for your help all. I think I have everything exept a better understanding of the connection to the door switch. Does anyone have more info as to where this circuit can be tapped? Is it possible to get the door switched power directly out of the interior fuse block? Thanks for the help.
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
